May 03, 2011, 1:01 PM
[CLOSED] Remote Load of Nodes and configured filters
Hello,
I have a problem with the combination of using filters to a tree and loading childnodes of a node remotely.
When I apply a filter my filter works fine on every node which is already loaded.
But the filter is not applied to the nodes which I load after I set up the filter.
Is there a property somewhere which I need to set to apply my configured filter to every node (not only the already loaded nodes)?
Regards,
Martin
I have a problem with the combination of using filters to a tree and loading childnodes of a node remotely.
When I apply a filter my filter works fine on every node which is already loaded.
But the filter is not applied to the nodes which I load after I set up the filter.
Is there a property somewhere which I need to set to apply my configured filter to every node (not only the already loaded nodes)?
Regards,
Martin
Last edited by Daniil; May 03, 2011 at 3:59 PM.
Reason: [CLOSED]